Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING A J-MODEL IN AN EXISTING WALL CASE
Read these instructions completely and carefully.
REMOVE LOCKING PLATE ON
1
FRONT LEFT SIDE
Locking
plate
Remove
screw
2
REMOVE ALL SHIPPING PADS
(IF PRESENT) INSIDE AIR
CONDITIONER NEXT TO
COMPRESSOR
3
CAREFULLY SLIDE AIR
CONDITIONER BACK INTO CASE
Make sure that the tubing on the unit does
not touch the wall case and that the case
installation is secure.
Installation Instructions
Remove
shipping
pads (if
present)
14
REINSTALL LOCKING PLATE WITH
4
TAB BEHIND WALL CASE FLANGE.
TIGHTEN SCREW
ATTACH POWER CORD TO BASE
5
PAN WITH CLAMP
ATTACH FRONT GRILLE
6
An opening for the power cord is on the
bottom of the front grille.
Base pan
Power
cord
Clamp
Publicidad
