Publicidad
NOTE: If you wish to use DoubleHaul in its half sized configuration proceed to page 5.
1
JOIN THE TWO HALVES TOGETHER.
Join the front and rear halves
together with the couplers. Using the
6mm hex wrench and the 13 x 19mm
open wrench. Install the hardware as
shown. Tighten to 10 Nm.
4X
2
LOOSEN THE MOUNTING PLATES.
Turn the thumbsrews
on the mounting
plates a few turns to
allow the mounting
2X
plate to slide freely.
Instruction #1035940C - Page 2 of 9
Publicidad
