Publicidad
Idiomas disponibles
Idiomas disponibles
How to Control Your Dehumidifier
All the basics you need to know!
Disclaimer: Pump, UV, and Wi-Fi features are only available on select models. It is normal for the
letters "CF" to be displayed for several seconds on Wi-Fi models as the dehumidifier powers on.
It is recommended to run the dehumidifier in Contentious mode for 24 hours for the first time. This
will stabilize the humidity and ensure that the compressor will function properly.
1.
Power On and Off - Press the
2.
MODE - Press the
Continuous.
3.
Dry - Press the
the desired relative humidity (RH) level between 35% - 80% RH. After a few seconds, the RH
of the room will be displayed. The fan speed will be set on low and cannot be adjusted.
4.
Turbo - Press the
target 35% RH. After a few seconds, the RH% of the room will be displayed. The fan speed will
be set on high and can not be adjusted.
5.
Comfort - Press the
target RH according to the ambient temperature. While in this mode, the RH mode can not be
manually set. After a few seconds, the RH of the room will be displayed. The fan speed will be
set on low and cannot be adjusted. In this mode, the screen will dim and eventually turn off
completely. To check the status, press the
6.
Continuous - Press the
to target 15% RH. The fan speed will be set on low and cannot be adjusted.
7.
Timer - The timer can be used to delay the appliance start-up or shutdown.
8.
Start-up - With the appliance off, press the
Then press the
After 5 seconds of inactivity, the Timer symbol will light up and this feature will be active.
once to turn on the appliance, push again to power off.
to toggle through the different modes: Dry, Turbo, Comfort or
until the Dry symbol is selected. Press the left and right buttons to set
until the Turbo symbol is selected. This will set the dehumidifier to
until the Comfort symbol is selected. This will automatically set the
until the Cont. symbol is selected. This will set the dehumidifier
or
buttons to increase or decrease the timer in 30 minute increments.
to temporarily wake up the display.
to enable this feature.
11
Publicidad
