Lenco DIR-250 Manual Del Usuario página 40

FM band, it stops when it has received a station. you may press
control to fine tune station, each step moves 0.05MHz.
Press and hold the Fav. button on the remote control and the device to save the station.
You can save up to 20 station, press Fav. button on the remote control to enter storing
station list, press the navigator on remote control to select and press OK button to play.
Alternatively, you can let the system scan ALL station for you by pressing OK, The searched
station will automatically be stored in Fav. station list.
6 DAB
Press the MODE on the remote control and the device (if in FM mode) to switch to DAB
mode. The display will show 'DAB/DAB+'.
* To listen to the stored DAB stations use either
buttons on the retome control to cycle through the stations. When you reach the desired
station, press the OK button on the remote control and press the NAVIGATE/OK knob on the
device in to begin playback of that station.
DAB quick scan
Press the Scan button button on the remote control or Left button on the device to begin
*
the scan. You will see the scan slide chart to indicate the progress.
* Once the scan has finished, the radio will select the first alphanumeric station and begin
playback.
Fav. Recall
Press and hold the Fav. button on the remote control and the device to save the station.
You can save up to 20 station, Press Fav., then press
Fav. button on the device to recall the saved station.
7 Bluetooth
Press mode repeatedly until "Bluetooth" appears on the display.
Make sure that no other Bluetooth device is connected to the radio. "Bluetooth
Disconnected" will appear on the display.
Enable the Bluetooth mode on the device that you want to connect to the DIR-250 and scan
for new devices.
Select the Lenco DIR-250 from the devices found on your device. If you are required to enter
a PIN code, enter 0000 (four zeros). Certain devices may also require you to approve the
connection.
Once the connection has been successful, "Bluetooth Connected" will appear on the display
of the Lenco DIR-250
and buttons or either
on the remote control or press
40
on the remote
and