Descargar Imprimir esta página

HeatStar HS115SF Instrucciones De Uso Y Manual Del Usuario página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
OPERATION (NO THERMOSTAT)
Plug in your unit using an appropriately sized properly
grounded three pronged extension cord. Attach the small
length of power cord on the heater to your extension
cord. Once power is supplied to the heater you should
see the green indicator light above the switch light up.
Before you turn on your heater you will want to ensure
that you make your rate selection. Refer to the "Rate
Selection" section for more information. You can now
flip your power switch to the ON position. After a few
seconds your heater will light and you should feel hot
air begin to emit from the outlet of the heater. With this
setup the heater will run continuously until the operator
flips the switch to the off position. If you would like your
heater to cycle on and off based on the temperature
of the space, you will need to use the supplied remote
thermostat.
OPERATION (WITH THERMOSTAT)
To operate your Nomad heater with a thermostat you will
need to place the thermostat in the environment to be
heated and turn the dial to the lowest temperature. Take
the "Piggy-Back" style plug end that was factory installed
on the thermostat and attach it to the small length of
power cord attached to the heater (located near the
power switch). The male plug end of the heater will
go inside the female receptacle on the thermostat plug
end. Next plug in your properly grounded three pronged
extension cord into the other side of the thermostat
plug. You can now switch on your heater and return to
where you have your thermostat located and set the
temperature at which you would like your heater to cycle
on and off at. Once the temperature in the space to be
heated drops below the point at which your thermostat
is set, the green indicator light above the switch will
illuminate and the heat sequence will begin. The unit
will continue to run until the setting of the thermostat
is satisfied. If your heater shuts down for any reason
other than the operator turns it off or the thermostat
is satisfied, refer to the troubleshooting portion of this
manual on page 11.
Forced-Air Single-Fuel NOMAD Construction Heater
INCLUDED THERMOSTAT
Part # 00618
PIGGY BACK PLUG
THERMOSTAT HOOKUP
Cord to heater
7
Operating Instructions and Owner's Manual
FIGURE 3
FIGURE 4
Extension cored to power
source
Cord to the
Thermostat

Publicidad

loading

Este manual también es adecuado para:

Hs190sfHs250sf