Publicidad
Idiomas disponibles
Idiomas disponibles
14. TROUBLESHOOTING
PROBLEM
The charger will not
turn on when properly
connected.
I cannot select a 6V or
12V setting.
CHARGING
orange) LED is flashing.
15. SPECIFICATIONS
Input Voltage ..................................................................120V AC @ 60Hz, 0.4A
Output Voltage .......................................6V or 12V, with Auto Voltage Detection
Output Current Rating ................................................ 1A @ 6V DC and 12V DC
16. REPLACEMENT PARTS
Battery clamp cable assembly ...................................................... 3899002668Z
Ring terminal cable assembly ....................................................... 2299002276Z
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
The quick-connect inline
fuse may be blown.
Reversing the connections
at the battery will cause this.
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
The charger is in abort
(yellow/
mode.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and
extension cord for loose
fitting plug.
Check the fuse. If it is
blown, replace it with one
of the same size and rating
(2A/32V).
No problem; this is normal.
See "Aborted Charge" in
Operating Instructions.
• 11 •
SOLUTION
Publicidad
