Publicidad
Idiomas disponibles
Idiomas disponibles
Installing/Removing Accessories
BD200TMT Oscillating Tool is specifically designed to work with Black & Decker
accessories, but is also compatible with many manufacturers' accessories. If unsure,
confirm with the specific manufacturer that their accessory is compatible.
CAUTION:
To avoid injury, do not use any accessory for an application where the
bolt and clamp washer may fail to hold the accessory.
CAUTION:
Read and follow all manufacturers' safety warnings for any accessories
used with this tool.
CAUTION:
To avoid injury, ensure adapter and
accessory are securely tightened.
• Clean any residual debris from the tool shaft and the
accessory holder.
• Position the accessory so the working edge is away
from the tool as shown in figure 1.
• Place the accessory on the front of the oscillating tool,
ensuring the accessory fully engages the pins.
• Place the washer (D) over the accessory with the
grooved side covering the pins.
• Slide the bolt (E) through the washer into the oscillating
tool and tighten with the hex wrench (F).
• To remove, loosen the bolt and washer with the hex wrench and remove the
accessory.
• To attach the sanding platen, loosen the bolt enough to slide the platen under the
washer (D), ensuring the platen fully engages the pins. Slide the hex wrench (F)
through the hole in the platen and tighten the bolt (E).
Assembly (BD200MT)
WARNINg:
source before making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
WARNINg:
touch workpiece or blade immediately after operating the
tool. They can become very hot. Handle carefully. Always
allow workpiece and accessories to cool before handling.
Installing/Removing Accessories
The BD200MT features an exclusive tool-free accessory
changing system. This allows for faster accessory
changes without the need for wrenches or hex keys like
other oscillating tool systems.
• Grasp the tool and squeeze the accessory clamping
lever (figure 2).
• Clean any residual debris from the tool shaft and the
accessory holder.
• Position the accessory so the working edge is away
from the tool as shown in figure 3.
• Slide the accessory between the shaft and the
accessory holder making sure the accessory fully
engages the pins on the holder and is flush with the
shaft.
• Release the accessory clamp lever.
Disconnect the plug from the power
Risk of lacerations or burns. Do not
1
2
3
7
D
E
F
Publicidad
