Klarstein 10031981 Manual De Instrucciones página 20

OPERATION
Starting
1. Take out the heater from the carton carefully. Please save the carton for off-season storage.
2. Make sure the power switch is in the OFF position before plugging it in.
3. Ensure the heater is fully assembled according to the Mounting Guide .
4. It is better not to use the same electric outlet with other high wattage electrical appliances in order to
avoid overloading your circuit.
Turn on
Plug in the unit, the power indicator lights up after a short buzz . Press „ 4 „ to turn on the unit, room tem-
perature is displayed while the whole screen will be light up and the default-factory set temperature is 35 °C.
Setting the temperature
Press" 1 „to set the temperature, " 10 „and" 9 „will flash , then press" 2 „or" 3 „arrow buttons to add 1"C or
reduce 1·c. The maximum setting temperature is 45"C, while the minimum one is 5"C. Keeping pressing" 2
„or" 3 „to add or reduce 1 ·c in 0. 5 S. The last setting temperature is the valid one. If no operation within
3S, the system will return the running state, " 9 „indicator will not flesh while room temperature is displayed.
Switching the display between degrees Fahrenheit and Celsius
Press the keys SET and UP (the two keys on the left) simultaneously for about 10 seconds.
Setting timer
Press" 1 „once again to set timer, setting time is displayed while timer indicator flesh (the timer unite is hour).
Pressing" 2 „or" 3 „to add or reduce 1 hour, the timer range is 0-2 4 hour.
Keeping pressing" 2 „or" 3 „to add or reduce 1 hour in 0.5 second. The factory-set timer is 0 hour. With indi-
cator lighting, the system starts to time according to last setting time if there is no operation for 5 seconds.
Each time" 2 „or" 3 „is pressed to set timer, system restarts to time by new time, or it does by original one till
timing is over, then turns off and stops working. The unit is turned off without buzz hint when timing is over.
Turn off
Keeping pressing" 4 „in any status to turn off the unit and power indicator keep light.
Children safety lock function
Under the working mode, press both" 2 „ or „ 3 „at the same time for 3 seconds to lock the system. Then a
square"[J"is displayed. Methods to unlock:
1. Shut off the electric machine.
2. Press both" 5" or „ 6 „for 3 seconds.
20