Product-Dependent Symbols; Symbols On The Product; Product Information; General Power Tool Safety Warnings - Hilti TE 50 Manual De Instrucciones Original

1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Drilling with hammering action (hammer drilling)
Chiseling
Drilling without hammering
Chisel positioning
Alternating current
Protection class II (double-insulated)
Revolutions per minute
Diameter
Lock symbol

1.4 Product information

Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product and its ancillary equipment can present hazards if used incorrectly
by untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are stated on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Breakers
Generation
Serial no.
2 Safety

2.1 General power tool safety warnings

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated (corded)
power tool or battery-operated (cordless) power tool.
2 English
Printed: 08.03.2017 | Doc-Nr: PUB / 5070997 / 000 / 03
TE 50 | TE 50­AVR
02