Hilti TE 50 Manual De Instrucciones Original página 15

5.4 Removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable
materials.
WARNING
Risk of injury! The accessory tool becomes hot in use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
Note
Use only genuine Hilti grease. Use of unsuitable grease may cause
damage to the product.
5.5 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel
positioning". Turn the function selector switch until it engages in the
"Chiseling" position.
Note
The chisel can be set to 24 different positions (in 15° increments). This
ensures that flat chisels and shaped chisels can always be set to the
optimum working position.
1. Set the function selector switch to the
2. Rotate the chisel to the desired position.
3. Set the function selector switch to the
switch engages.
◁ The tool is ready for use.
5.6 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
◁ The depth gauge is fitted. To set the drilling depth:
4. Release the screw at the depth gauge.
Printed: 08.03.2017 | Doc-Nr: PUB / 5070997 / 000 / 03
5
6
3
position.
position and make sure the
English 9