Hilti TE 50 Manual De Instrucciones Original página 19

Trouble or fault
The power tool
doesn't start and the
service indicator
blinks red.
The drill bit doesn't
rotate.
The chisel cannot
be released from the
chuck.
8 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about
the warranty conditions.
Printed: 08.03.2017 | Doc-Nr: PUB / 5070997 / 000 / 03
Possible cause
A fault has occurred in
the tool.
The function selector
switch is not engaged or
is in the "drilling without
hammering" or ham-
mer drilling position.
The chuck is not pulled
back fully.
Action to be taken
▶ Have the tool repaired
by a trained electrical
specialist.
▶ Set the function selec-
tor switch to "Drilling
without hammering"
or "Hammer drilling"
.
▶ Pull the chuck back
as far as it will go and
remove the accessory
tool.
English 13