Garland BULL 861 QG Manual De Instrucciones página 48

English
vapors contain carbon monoxide and harmful chemicals.
In case of a concentration of gases produced by poor
ventilation, remove all that impedes the flow of clean air to
improve ventilation from the work area and not return to
work in the area unless you have properly ventilated area
and have clear that ventilation is sufficient so that does not
happen this concentration again.
Work only in daylight or good artificial light. Do not use
this machine at night, with fog or with a low visibility
which do not allow you to clearly see the working area.
Limit continued use of this machine to a 10 minute
time limit and between 10 and 20 minutes to rest
between each session.
If you slip or fall, stop acceleration and move the
switch to the "OFF position" ().
Do not use this machine if you are tired, ill, have taken
drugs, narcotic drugs or alcohol. The lack of rest and
fatigue can cause accidents or damage.
Always readjust the machine on a flat and stable
surface.
Do not use the machine on steep slopes where you
cannot guarantee their safety. If you are working on
slopes slow down your work pace and ensure you
have good stability.
Be alert when you back-up or pull the machine
towards you.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine. If
you detect any anomaly immediately stop the machine
and check it carefully. In case of mechanical failure
take the machine to the technical service for repair.
You should not continue working if you notice that the
operation is not correct.
Remember to always use the machine with clean
hands and without any fuel or oil remains.
Clean the work area and remove all obstacles that may
cause accidents. Check the work area when going to
work and remove all items that could become entangled
in the cutting tool. Also remove all the objects that the
cutting tool can violently eject in the operation.
Do not allow anyone to enter the work perimeter. This
work perimeter must be 15 meters and is a danger
zone.
Never leave this machine unattended.
Be careful not to touch the hot parts of the
machine while the engine is running or after
use, such as exhaust, spark plug or high
voltage cables.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
Always follow the safety rules given in this manual.
7.1. HOLDING AND GUIDING THE MACHINE
While working always place yourself
behind the machine and hold it firmly
with both hands on the handles.
Warning! Do not use this rotary tiller with one
hand.
Warning! This rotary tiller could bounce upwards
or jump forwards unexpectedly. If the teeth hit
something hard that is buried in the ground such as
48/180