Fanimation BECKWITH FP7964B Serie Manual De Instrucciones página 7

1. Remove the hanger ball
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the black, white and blue wires and safety cable
through the downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through Motor Coupling Cover, Canopy
Screw Cover and Ceiling Canopy. (Figure 5)
How to Assemble Your Ceiling Fan
portion from the downrod/
Downrod
Set Screw
Hairpin
Clip
Set Screws (2)
Set Screws and
Locking Nuts (2)
Motor Coupling
Cover
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, White, Blue wires
and Safety Cable
Downrod
Figure 3
Downrod
Clevis Pin
Hairpin Clip
Figure 4
Ceiling Canopy
Canopy Screw
Cover
Figure 5