Samsung NE59J7750Serie Manual Del Usuario página 52

Troubleshooting
DRAWER
Problem Possible cause
The Drawer The drawer is out of
does not slide alignment.
smoothly or
drags.
The drawer is over-loaded or
the load is unbalanced.
The Warming A fuse in your home may
drawer will not be blown or circuit breaker
work. tripped.
The controls are not set
correctly.
Excessive There is liquid present in the
condensation drawer.
in the drawer.
Uncovered foods.
The temperature is set too
high.
Food dries out Moisture is escaping.
in the warming
The drawer is not fully closed.
drawer.
52 English
Solution
Fully extend the drawer and
push it all the way in. See the
page 39.
Reduce weight. Redistribute
drawer contents.
Replace the fuse or reset the
circuit breaker.
See the chapter on using the
warming drawer on page 39.
Remove the liquid.
Cover food with a lid.
Adjust the temperature to a
lower setting.
Cover food with a lid.
Push the drawer in until the
latch engages.
Information codes
OVEN
Displayed
Possible cause
code
C-20 The oven sensor is open when
the oven is operating.
The oven sensor is short when
the oven is operating.
C-21 This code occurs if the internal
temperature rises abnormally
high.
C-d1 This code occurs if the door lock
is mispositioned.
C-d0 This code occurs if the Control
key is short for 1 minute.
C-F0 This code occurs if
communication between
the Main and Sub PBA is
interrupted.
-dC- This code appears if the
partition is inserted or removed
while the oven is operating.
Solution
Press OVEN OFF and restart the
oven. If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power. If
this does not solve the problem,
call for service.
Make sure the partition is
inserted properly, and restart
the oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power. If
this does not solve the problem,
call for service.