Descargar Imprimir esta página

Campbell Hausfeld AF010400 Manual De Instrucciones página 7

Publicidad

DIMENSIONES
Long.
Anch.
Alt.
CONOZCA SU UNIDAD
Medidor analógico
Linterna LED
Interruptor de
ENCENDIDO / APAGADO
Aguja para inflar
Boquilla para inflar
Figura 1
20,32 cm
8,89 cm
15,86 cm
Cable de alimentación
de 12 V
Manguera
para inflar
Válvula PRESTA
Conector de
manguera de aire
Sp2
General Safety
Always operate this tire inflator in an open and well-ventilated area and
not inside a confined area, such as a garage. Doing so may lead to bodily
harm or asphyxiation resulting in death.
Do not leave the inflator unattended while the unit is running.
Wear eye protection during the inflation process. Never exceed the
recommended pressure for any inflatable object. Do not over inflate
objects as objects may rupture/explode causing serious injury and/or
property damage.
The air hose connector must be properly connected to secure the
inflation accessories. Use extreme caution when using inflation
accessories.
Always put the car in park; set the emergency brake; and "chock" the
wheels before using the inflator as personal injury and/or property
damage may occur.
Tire inflation should only be done safely away from the roadway, with
use of triangles or flares, and in compliance with the vehicle's operating
manual.
Always use a separate pressure gauge to check the actual pressure in
tires and in low pressure inflatable objects.
Inflator must cool for 20 minutes after 20 minutes of continuous
operation. The inflator is not designed to operate continuously for more
than 20 minutes. Exceeding recommended run-time or not allowing for
adequate cooling will cause inflator to overheat and could damage or
destroy inflator.
When using inflator on high pressure tires, such as those used on large
trucks, trailers or tractors, tire inflation must be executed in stages--NOT
exceeding the 20 minutes of run-time and NOT omitting the 20 minutes
of cooling required for proper use of this inflator.
Make sure the air hose connector is properly connected to the valve
stem. Failure to properly connect the air hose will result in slower
inflation and/or no air getting to the tire.
Inflator will get hot to the touch and may cause serious injury--do not
hold or touch while operating. Keep away from flammable materials.
5

Publicidad

loading