Star Progetti 44B15 Instrucciones De Uso página 15

3. USES
• HELIOSA 44 models are particularly suitable for uses for inside areas or outside areas.
4. TECHNICAL DATAS - HELIOSA® HI DESIGN 44
*HEATED AREAS
The heated areas indicated can vary according to the installation height, the environmental conditions and the synergy produced when
several heaters installed. In the latter case results can be significantly higher.
5. INSTALLATION TO WALL (see page 47)
Install the heater on the wall at a minimum distance of 20 cm from the ceiling (see installation examples). The height at which the heaters
are normally installed varies from 2.3 meters to a maximum of 2.5 metres.Wall mounting is the ideal solution to achieve the best results
in terms of heat with the reflector at a 45° angle and the heater perfectly horizontal. The appliance must not be placed immediately
below a mains socket.
6. INSTALLATION IN BATH ROOM
Where the appliance is being installed in either bathroom, shower room, WC, please ensure that all switch-gear complies with Health &
Safety requirements.
7. POSITIONING OF HELIOSA® HI DESIGN 44
1.Aim the HELIOSA® 44 reflector in the direction required for the wall-mounted installation. The normal angle is 45° to the horizontal
plane.
2. Never install HELIOSA® 44 an inflammable surface or facing an inflammable surface.
3. HELIOSA® 44 must be placed at a clear distance (line of vision) of not less than 2.0 metres from objects such as cardboard, fabrics,
curtains and windows. If used in workshops and garages where there are inflammable paints, HELIOSA 44 must be located more than
metres from the hazard.
4. We recommend that the heater is not used in dusty non-ventilated environments to avoid damage to the bulb.
8. WIRE GUARD
a) The wire guard should be used if protection is required (for example sports halls or places where games are played). In areas where
indoor football is played, it may be necessary to fit additional external guarding to cope with the force of impact.
b) The wire guard is simply clipped over the front of the reflector.
c) The wire guard must be installed when the heater is fixed under a height of 2,5 m from the floor level and this assembly must be done
during installation and by a qualified electrician.
d) The HELIOSA® 44 protective wire guard has been designed to prevent direct access to the heating elements and must not be removed
while the heater is being used.
e) The guard does not guarantee full protection for children or the disabled.
15