Philips SCD560/00 Manual Del Usuario página 8

What to do if no link is established
• The parent unit may be out of range
of the baby unit. Place the parent unit
closer to the baby unit, but not closer
than 1 metre/3.5 feet.
• The baby unit or the parent unit may
lose connection because it is too
close to another DECT appliance
(e.g. a cordless phone). Switch off this
DECT appliance or place the unit
further away from this appliance.
• The baby unit may be switched off.
Switch on the baby unit.
4.2.1 Operating range
• The operating range is 330 metres/1000 feet
outdoors and up to 50 metres/150 feet
indoors.
• The operating range of the baby monitor
varies depending on the surroundings and
factors that cause interference. Wet and moist
materials cause so much interference that
the range loss is up to 100%. For interference
from dry materials, see table below
Dry materials
Wood, plaster,
cardboard, glass
(without metal,
wires or lead)
Brick, plywood
Reinforced concrete
Metal grilles or bars
Metal or aluminium
sheets
8
Material Loss of
thickness range
< 30cm 0-10%
(12in)
< 30cm 5-35%
(12in)
< 30cm 30-100%
(12in)
< 1cm 90-100%
(0.4in)
< 1cm 100%
(0.4in)
5 Functions and
feedback on the
baby unit
5.1 Nightlight
The nightlight produces a soft glow that comforts
your baby.
Press the nightlight on/off button on the baby
1
unit to switch on the nightlight.
• Q appears on the display of the parent unit.
Press the nightlight on/off button again to
2
switch off the nightlight.
The nightlight dims gradually before it goes
•
out completely.
Q disappears from the display of the parent
•
unit.
5.2 Lullaby function
Press the lullaby play/stop button K on the
1
baby unit to play the last selected lullaby.
The selected lullaby repeats for 15 minutes.
•
If no lullaby was selected before, lullaby 1
•
is played.