LG WT6105C Serie Manual Del Operador página 23

en-us_main.book.book Page 23 Friday, December 2, 2022 4:16 PM
5
Wipe off any moisture with a dry towel or
cloth after cleaning.
6
To clean the drawer opening, use a small,
non-metal brush to clean the recess. Remove
all residue from the upper and lower parts of
the recess.
7
Return the inserts to the proper
compartments and replace the drawer.
• Set the drawer into the opening at an angle,
then lower it and slide it into place.
Cleaning the Bleach Dispenser
Bleach may build up on the bleach dispenser
cover. Check for buildup and clean the cover once
or twice a month.
Automatic Bleach Dispenser
Remove the cover from the bleach dispenser.
Clean the cover and the opening with warm water.
Immediate Bleach Dispenser
The cover cannot be separated from the dispenser.
Clean the cover using a brush and warm water.
Cleaning the Water Inlet Filters
If the washer does not fill properly, the Warm LED
may flash. The inlet valve filter screens could be
clogged by hard water scale, sediment in the water
supply, or other debris.
WARNING
• The inlet screens protect the delicate parts of the
inlet valve from being damaged by particles that
could enter the valves with the water supply.
Operating the washer with these filters removed
could cause a valve to open continuously,
resulting in flooding and/or property damage.
CAUTION
• Do not use the washer without the inlet filters.
Doing so it will cause leaks and malfunction.
• If you use the washer in an area with hard water,
the inlet filter may clog due to lime buildup and
require more frequent cleaning.
1
Turn off the washer, and unplug the power
cord.
2
Turn off hot and cold water faucets.
3
Unscrew the hot and cold water hoses from
the back of the washer.
4
Remove the filters from the water valves
carefully.
• Use pliers to pull out the filters from the
water valves.
5
Remove foreign objects and soak the filters in
white vinegar or a lime scale remover.
• If using a lime scale remover, follow the
manufacturer's instructions. Be careful not
to damage the filters while cleaning them.
6
Rinse filters thoroughly and press them back
into place.
7
Flush then reattach the water hoses.
• Before reattaching the water inlet hoses,
flush them by running several gallons of
water through them into a bucket or drain,
MAINTENANCE 23