Publicidad
Idiomas disponibles
Idiomas disponibles
USE & OPERATION (CONTINUED)
FILLING WITH WATER (CONTINUED)
You can use the Continuous Water Supply Connection to run the unit for longer periods of time
without refilling the tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is connected to a mains water supply.
Note: The garden hose is not included. Please make use of a garden hose which is compatible with
the unit connection.
•
Locate the male connector at one end of the garden hose. Insert
the garden hose connector into the water inlet valve of the cooler.
Screw and tighten the water inlet valve onto the threaded part of
the garden hose connector, making sure the hose connector is
secured to ensure there will be no leaks. If there is a leakage, the
hose and the water inlet valve may not be connected properly.
Try to disconnect, replace and tighten the water inlet valve again.
•
When the connection is secured, turn ON the water supply and
the water will flow into the water tank of the cooler.
•
The cooler is now set so the water refills automatically.
•
When the water tank is full of water, the water inlet valve will
automatically stop the water supply from overflowing the water tank.
WARNING: The maximum water inlet pressure is 0.5 MPa.
EN
6
Water Inlet Valve
Garden Hose
Publicidad
