Fanimation LP8066LBN Manual De Instrucciones página 9

WARNING
To avoid possible re or shock, be sure electricity is
turned off at the main fuse box before hanging.
(Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7' of clearance
from oor to blades. (Figure 2)
1. Securely attach the hanger bracket to the outlet box
using the outlet box screws and flat washers supplied
with the outlet box. (Figure 3)
WARNING
The outlet box must be securely anchored. Hanger
bracket must seat rmly against outlet box. If the
outlet box is recessed, remove wall board until bracket
contacts box. If bracket and /or outlet box are not
securely attached, the fan could wobble or fall.
2. Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached
to the outlet box. Be sure the groove in the ball is lined
up with tab on the hanger bracket. (Figure 4)
This fan is intended for standard and angled mounting
options only. Closemount and flushmount options are
not available. For angled ceilings, note the angle can
be no more than 19°.
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or re hazard.
WARNING
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.
How to Hang Your Ceiling Fan
Ceiling
Floor
Outlet Box
Hanger
Bracket
Flat Washer
Screw (2) Supplied
with outlet box
Hanger
Bracket
9
Main Fuse Box
Figure 1
No Less
than
7 Feet
Figure 2
Tab
Figure 3
Downrod/Hanger
Ball Assembly
Figure 4
Outlet Box