Concept RK4120 Manual Del Usuario página 37

OPERATING INSTRUCTIONS
1. Remove the kettle from the base (6), press the button for opening the lid (4), open the lid (1), and fill the appliance
with cold water within the permitted maximum only. If the water level in the kettle is under the recommended
minimum, the kettle will keep overheating and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn off automatically.
2. Place the kettle on the base (6); electric contacts will get connected automatically. Thanks to the central connector
design, the kettle can turn around 360° and be put on the base from any side.
3. Connect the base to the mains. A sound signal beeps, LED backlight turns red, green, blue gradually. The
temperature selection backlight also lights up for a moment. The sound signal beeps again. At this point the kettle
is ready for operation.
4. Turn the kettle on by pressing the switch ON/OFF (7).
5. The kettle automatically boils water at 10After reaching the boiling point, you hear 2times an audible signal and the
kettle switches off automatically. By pressing the ON/OFF button you can stop the heating process early.
6. Selecting a programme: set the required heating temperature by pressing the + / – (8) buttons. You can select
from the following programmes: 50°C, 70°C, 80°C, 90°C, 100°C. Once it reaches the required temperature, you
will be notified twice by a beep.
7. The selected program is accompanied by the colour of the backlight, which goes off after it reaches the boiling
point: 50°C green, 70°C blue, 80°C purple, 90°C light green, 100°C red.
8. ENKEEP WARM function - if you want the kettle to hold the temperature for up to 30 minutes, choose the
temperature by the +/- (8) buttons and hold down the ON / OFF button (7) for 3 seconds. The backlight of the
selected temperature starts to blink and the sound signal beeps. The kettle warms up the water to the selected
temperature and holds it for up to 30 minutes. The KEEP WARM function can be canceled by pressing the ON / OFF
button (7).
Note: It is not a sign of a defect when a small amount of water droplets appear on the kettle base (7). It is a small amount
of condensed steam, which deactivates the kettle thermostat.
CLEANING AND MAINTENANCE
Warning!
Prior to each cleaning operation disconnect the lead-in cable of the appliance from el. socket! Prior to start any
handling operation, make sure that the appliance is cooled down!
Use only a wet rag for cleaning surface of the appliance, do not use any cleansers or hard things which could damage
the surface!
Never clean the appliance under running water, never flush it and never immerse the appliance into water!
Scale removal
During common use water impurities are deposited. Use commercially available agents for scale removal (observe
manufacturer's instructions).
Note: Remove the deposits regularly, once a week as a rule – periodicity depends on water hardness and on frequency
of kettle use. The deposits reduce efficiency and service life of the appliance materially.
RK4120
EN
37