Publicidad
Idiomas disponibles
Idiomas disponibles
4. Slide out the internal glass as shown below. Pull out the
second and third glass panels (intermediate panels) to clean them.
5. Replace the middle panes after cleaning in reverse order,
checking that they are oriented so the words INTERNAL
SIDE are properly legible.
NOTE: a slight gap between the middle panes and the side
supports is normal because it allows for the heat
expansion of the glass.
6. Place the inner glass between the two uprights and put the
upper strip back in place.
Replacement of the oven light
WARNING
Make sure that:
• The oven and lights are cool and power to the oven
has been turned off before replacing the light bulb(s).
Failure to do so could result in electrical shock or burns.
• The lenses must be in place when using the oven.
• The lenses serve to protect the light bulb from breaking.
• The lenses are made of glass. Handle carefully to avoid
breakage. Broken glass could cause an injury.
1
(230V - 15 or 25W)
2
1
1 Turn off power at the main power supply (fuse or breaker
box).
2 Remove the lens (1) by unscrewing it.
3 Remove the light bulb (2) from its socket (3).
4 Replace the bulb (2) with a new one. Avoid touching the
bulb with fingers, as oils from hands can damage the
bulb when it becomes hot.
5 Use one with the same Volt and Watt (see figure).
6 Screw the lens (1) back on.
7 Turn power back on at the main power supply (fuse or
breaker box).
3
2
(230V - 25W G9)
3
EN
33
Publicidad
