Publicidad
Idiomas disponibles
Idiomas disponibles
To check lower guard, open lower guard by hand, then release and watch guard closure.
Also check to see that Retracting Lever does not touch tool housing. Leaving blade exposed
is VERY DANGEROUS and can lead to serious personal injury.
3.
Check the operation and condition of the lower guard spring. If the guard and the spring are not operating
properly, they must be serviced before use. Lower guard may operate sluggishly due to damaged parts,
gummy deposits, or a buildup of debris.
4.
Lower guard should be retracted manually only for special cuts such as "Pocket Cuts" and "Compound
Cuts." Raise lower guard by Retracting Lever. As soon as blade enters the material, lower guard must be
released. For all other sawing, the lower guard should operate automatically.
5.
Always observe that the lower guard is covering the blade before placing saw down on bench or floor. An
unprotected, coasting blade will cause the saw to walk backwards, cutting whatever is in its path. Be aware
of the time it takes for the blade to stop after switch is released.
6.
NEVER hold piece being cut in your hands or across your leg. It is important to support the work properly to
minimize body exposure, blade binding, or loss of control.
7.
Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact
hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the tool
"live" and shock the operator.
8.
When ripping, always use a rip fence or straight edge guide. This improves the accuracy of cut and reduces
the chance for blade binding.
9.
Always use blades with correct size and shape (diamond vs. round) arbor holes. Blades that do not match
the mounting hardware of the saw will run eccentrically, causing loss of control.
10. Never use damaged or incorrect blade washers or bolts. The blade washers and bolt were specially
designed for your saw, for optimum performance and safety of operation.
11. Causes and Operator Prevention of Kickback:
Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an
uncontrolled saw to lift up and out of the work piece toward the operator.
• When the blade is pinched or bound tightly by the kerf closing down, the blade stalls
and the motor reaction drives the unit rapidly back toward the operator.
• If the blade becomes twisted or misaligned in the cut, the teeth at the back edge of
the blade can dig into the top surface of the wood causing the blade to climb out of
the kerf and jump back toward the operator.
• Kickback is the result of tool misuse and/or incorrect operating procedures of
conditions and can be avoided by taking proper precautions as given below:
12. Maintain a firm grip on the saw and position your body and arm in a way that allows you to resist KICKBACK
forces. KICKBACK forces can be controlled by the operator, if proper precautions are taken.
13. When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw
motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from
the work or pull the saw backward while the blade is in motion or KICKBACK may occur. Investigate and
take corrective actions to eliminate the cause of blade binding.
14. When restarting a saw in the work piece, center the saw blade in the kerf and check that
teeth are not engaged into the material.
from the work piece as the saw is restarted.
15. Support large panels to minimize the risk of blade pinching and KICKBACK. Large panels tend to
sag under their own weight. Supports must be placed under the panel on both sides, near the line of
cut and near the edge of the panel.
English
If saw blade is binding, it may walk up or KICKBACK
Publicidad
