Publicidad
Idiomas disponibles
Idiomas disponibles
liquid may be flammable if exposed to
spark or flame.
• Charge the battery packs only in
PORTER-CABLE chargers.
• DO NOT splash or immerse in water or other
liquids. This may cause premature cell failure.
• Do not store or use the tool and battery
pack in locations where the temperature
may reach or exceed 105°F (40˚C) (such as
outside sheds or metal buildings in summer).
WARNING:
the battery pack for any reason. If battery
pack case is cracked or damaged, do not
insert into charger. Do not crush, drop or
damage battery pack. Do not use a
battery pack or charger that has received
a sharp blow, been dropped, run over or
damaged in any way (i.e., pierced with a
nail, hit with a hammer, stepped on).
Damaged battery packs should be
returned to service center for recycling.
WARNING:
or carry battery so that metal objects can
contact exposed battery terminals. For
example, do not place battery in aprons,
pockets, tool boxes, product kit boxes,
drawers, etc., with loose nails, screws, keys,
etc. Transporting batteries can possibly
cause fires if the battery terminals
inadvertently come in contact with
conductive materials such as keys, coins,
hand tools and the like. The US Department
of Transportation Hazardous Material
Regulations (HMR) actually prohibit
transporting batteries in commerce or on
airplanes (i.e., packed in suitcases and
carry-on luggage) UNLESS they are
properly protected from short circuits. So
when transporting individual batteries, make
sure that the battery terminals are protected
and well insulated from materials that could
contact them and cause a short circuit.
NOTE
:
Lithium-Ion batteries should not
be put in checked baggage.
STORAGE RECOMMENDATIONS
1. The best storage place is one that is
cool and dry away from direct sunlight and
excess heat or cold.
2. Long-term storage will not harm the
battery pack or charger as long as the
battery is not depleted.
IMPORTANT CHARGING NOTES
1. Longest life and best performance can be
obtained if the battery pack is charged when
the air temperature is between 65°F and
75°F (18°- 24°C). DO NOT charge the battery
pack in an air temperature below +40°F
(+4.5°C), or above +105°F (+40.5°C). This is
important and will prevent serious damage to
the battery pack.
2. The charger and battery pack may become
This product uses the batteries and chargers listed below.
20V Max* Lithium-Ion Batteries: PCC680L, PCC681L, PCC685L, PCC682L
20V Max* Lithium-Ion Chargers: PCC690L, PCC691L, PCC695L, PCC692L
Never attempt to open
Fire hazard. Do not store
warm to touch while charging. This is a normal
condition, and does not indicate a problem. To
facilitate the cooling of the battery pack after
use, avoid placing the charger or battery pack
in a warm environment such as in a metal
shed, or an uninsulated trailer.
3. If the battery pack does not charge
properly:
a. Check current at receptacle by
plugging in a lamp or other appliance.
b. Check to see if receptacle is
connected to a light switch which turns
power off when you turn out the lights.
c. Move charger and battery pack to a
location where the surrounding air
temperature is approximately 65°F -
75°F (18°- 24°C).
d. If charging problems persist, take the
tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged
when it fails to produce sufficient power
on jobs which were easily done previously.
DO NOT CONTINUE to use under these
conditions. Follow the charging procedure.
You may also charge a partially used pack
whenever you desire with no adverse
affect on the battery pack.
5. Foreign materials of a conductive
nature such as, but not limited to, steel
wool, aluminum foil, or any buildup of
metallic particles should be kept away
from charger cavities. Always unplug the
charger from the power supply when there
is no battery pack in the cavity. Unplug
charger before attempting to clean.
6. Do not freeze or immerse charger in
water or any other liquid.
WARNING:
allow any liquid to get inside charger.Never
attempt to open the battery pack for any
reason. If the plastic housing of the
battery pack breaks or cracks, return to a
service center for recycling.
Recharge discharged batteries as soon as possible
after use or battery life may be greatly diminished.
FUNCTIONAL DESCRIPTION
FIGURE A
1. Trigger Switch
2. Lock-Off Button
3. Spindle Lock Button
4. Spindle (not shown)
5. S ide Handle
6. Abrasive Wheel
7. Unthreaded Backing Flange (not shown)
8. Threaded Clamp Nut (not shown)
9. Guard (Type 1, Type 27)
8
Shock hazard. Do not
Publicidad
