Ryobi RY24000 Manual Del Operador página 12

pRoblEM
Line will not advance when using
the auto-feed head:
Grass wraps around boom
housing and line head
Motor fails to start when switch
trigger is depressed.
TRoUblEshooTINg
possIblE CAUsE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground
level.
Battery is not secure.
Battery is not charged.
CALL US FIRST
For any questions about operating or maintaining your product,
call the Ryobi
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
10 — English
solUTIoN
Lubricate with silicone spray.
Install more line. Refer to line Replacement
earlier in this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to
line Replacement earlier in this manual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latches on each side of the battery pack snap
into place.
Charge the battery pack according to the
instructions included with your model.
Help Line!
®