5. MAINTENANCE
The only service required for maintaining proper operation is the periodic replacement of the
battery in the receiver.
A. Connecting the Transmitter Battery
IMPORTANT: The battery is already installed in the 2000H Transmitter, but is not connected
until the fuse and fuse holder cap are installed.
1. While holding the fuse holder cap, insert the fuse barrel into the opening on the left side of
the transmitter.
2. Turn the fuse holder cap until secure.
3. Charge the transmitter battery before storing the unit. Never allow the unit to sit for any
length of time with a low or discharged battery.
B. Replacing the Receiver Battery
1. Remove the two screws on either side of the 2000R Receiver.
2. Separate the case and replace the 9 volt battery. Observe polarity.
3. Re-assemble the case and re-install the screws.
Do not overtighten the screws.
C. Cleaning
Periodically wipe with a damp cloth and mild detergent; do not use abrasives or solvents.
One-Year Limited Warranty
Tempo Communications warrants to the original purchaser of these goods for use that these
products will be free from defects in workmanship and material forone year, excepting normal
wear and abuse. For all Test Instrument repairs, you must first request a Return Authorization
Number by contacting our Customer Service department at:
Telephone: 760 510-0558
UK Tel: +44 1633 927 050
This number must be clearly marked on the shipping label. Ship units Freight Prepaid to:
Tempo Repair Center,
1390 Aspen Way, Vista CA 92081 USA.
Mark all packages:
Attention: TEST INSTRUMENT REPAIR.
For items not covered under warranty (such as dropped, abused, etc.) repair cost quote
available upon request. Note: Prior to returning any test instrument, please check to make sure
batteries are fully charged.
Brecon House, William Brown Close Cwmbran, NP44 3AB
Tempo Communications Inc.
Customer Service: (800) 642-2155
Fax: (760) 598-9263
Telephone: (760) 510-0558
UK (EMEA) Tempo Europe Ltd.
UK Tel: +44 1633 927 050
www.TempoCom.com
7