Lavorwash ETNA 3000 Manual página 14

DESCRIPTION AND ASSEMBLY
A
Motor head
B
ON/OFF main switch
C
"No water" light
D
"Steam ready" light
E
ON/OFF boiler switch
F
Steam adjustment knob
G Hooks for closing head/drum
J
Water tank
J
Detergent tank
1
K
Water level sensor
H
Vacuum connection
H
Nozzle of the flexible hose
1
H
Outlet plug for steam
2
I Drum
L
Flexible hose
L
Suction motor button
1
L
Steam delivery safety lock
2
L
Steam lever
3
L
Flexible hose, blower
4
M
Air filter
USAGE
• The appliance is intended for professional
use.
• The appliance is intended for use as a wet
and dry vacuum cleaner.
• If the device is used for particularly fine pow-
ders (smaller than 0,3 µm), special filters sup-
plied optionally (Hepa) must be employed.
GENERAL WARNING
• Components contained in the package
(e.g. plastic bags) could be dangerous; keep
them out of reach of children and pets.
• The use of this machine for anything not
specified in this manual may be dangerous
and must be avoided.
• The manufacturer cannot be held re-
sponsible for any damage/injury caused to
persons, animals or property caused by mis-
use of the appliance, not in compliance with
14
N
Small nylon brush
N
Small brass brush
1
N
Small S/S brush
2
O Extension tube
P
OFF injection pump switch
I - Selector detergent
II -Selector hot water
Q
Floor fitting
Q Liquid fitting
1
Q
Carpet fitting
2
R Pressure gauge
S
Round suction brush
S
Brush for small rectangular nozzle
1
T
Big nozzle brush for steam/suction
T
Small rectangular nozzle steam/suction
1
T
Small nozzle brush for steam/suction
2
U
Window wiper steam/suction
U Window wiper for small rectangular nozzle
1
X
Suction flat lance
Y
Accessory connection with steam/suction nozzle
Z
Drain hose system
manual instructions.
• Plug in the appliance only if the power
voltage is the same shown on the rating
plate and only if the power supply mains has
a protective earthing system.
• Do not pull the plug by its cable.
• Do not drag the appliance by its power
cable.
• Unwind the power cable completely be-
fore use.
• Avoid using electrical extension cables;
if necessary, use an extension cable with a
safety approval mark with a protective earth-
ing system. Minimum size of extension cable
is 2.5 mm².
• Never carry out any maintenance on the
machine without first disconnecting from the
mains supply or when it is left unattended or
reachable by children or disables.
EN