Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (continued)
10. Remove the wiring box cover from the fan housing (A). Pull
the house wires through the hole in the wiring box cover. Using
the quick connectors, connect the house wiring to the LED
wall switch (E) and fan housing (A). 14 AWG is the smallest
conductor that should be used for branch circuit wiring. Please
refer to the wiring diagram on page 5 to ensure proper wire
connections are made. Carefully push the wire connections into
the wiring box and reattach the wiring box cover.
NOTE: Do not use metal wall plate with the LED wall switch (E),
as it may cause interference with the fan operation.
CAUTION: The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not
present, one must be run by a qualified electrician. If
you require assistance, please call 1-877-319-3757 before
attempting switch installation.
CAUTION: This switch is intended to only operate with this
bath fan. Connections to other electrical fixtures are prohibited
and could cause electrical issues.
11. Connect a 4 in. circular duct to the fan housing (A), securing
it with duct tape or a clamp. Vent the duct to the outside.
12. Join the connectors from the fan housing (A) and the grille (B).
The grille (B) must be connected BEFORE turning on power
to the fan.
13. Attach the grille (B) by pinching the mounting springs
and inserting into the narrow rectangular slots in the
fan housing (A).
Turn on the power source. Test the unit.
10
A
11
12
A
Connectors
13
Mounting
spring
8
Wiring box cover
Quick connector
Wiring box cover
A
B
A
Homewerks.com
B
Publicidad
