Publicidad
Idiomas disponibles
Idiomas disponibles
Figure A
Figure B
ADJUSTING THE HANDLEBAR
Loosen the L Shaped Knob (No. 16) to raise or lower the
Handlebar (No. 26) to the desired position. Make sure the L
Shaped Knob (No. 16) settles into the desired hole and
secure it firmly by turning clockwise. See Figure A.
Loosen the L Shaped Knob (No. 27) to move the Handlebar
(No. 26) forward or backward to the desired position. Once
the Handlebar (No. 26) is in the desired position, firmly
secure the L Shaped Knob (No. 27) by turning clockwise.
See Figure B.
ADJUSTING THE PEDAL STRAP
Place the ball of each foot in the toe clips so the front of your
shoe fits snugly in the toe clip cage. Rotate one foot to within
arm's reach and pull the strap until the top clip cage fits your
shoe snugly. Insert the strap back into the hoop of the toe clip.
Repeat this for the other foot.
DISMOUNTING THE BIKE
WARNING! Do not dismount the bike or remove your feet
from the pedals until the pedals have stopped completely. You
can stop the flywheel at anytime by pushing down on Brake
Knob (No. 31).
MOVING THE BIKE
To move the bike, first ensure that the Handlebar (No. 26) is
properly secured. If the Handlebar (No. 26) is loose, tighten
the L Shaped Knobs (No. 16 & No. 27) to secure it. Next,
stand at the front of the bike so that you're directly in front of
the Handlebar (No. 26). Firmly grasp and hold each side of
the Handlebar (No. 26), place one foot on the Front
Stabilizer (No. 2) and tilt the bike towards you until the
Wheels (No. 11) on the Front Stabilizer (No. 2) touch the
ground. With the Wheels (No. 11) on the ground, you can
transport the bike to the desired location with ease.
21
Publicidad
