Publicidad
Idiomas disponibles
Idiomas disponibles
5
Adjust the shift (image position)
LENS
●
After adjusting the image position, it may be necessary to
select "Pixel Adjust" from the Settings menu "Installation".
(Reference page:
●
Every time the
item will be switched among "Focus", "Zoom" and "Shift".
It can also be switched with the button.
OK
LENS
6
Turn off power source
STAND BY
While a confirmation screen is displayed
STAND BY
STAND BY/ON
Cool Down mode
STAND BY/ON
●
When power off, the lens cover will be closed.
Set the lens cover.
●
The power cannot be turned off within approximately 90
seconds after it has been turned on. Start operation only
after 90 seconds time.
You can also press the
●
the power. (Reference page: 16)
●
Pull out the power plug when the unit will not be used for a
prolonged time.
Lens Control
Shift
Adjust accordingly
Select
Back
Operate
BACK
by pressing the
up/down/left/right
66
to
67)
button is pressed, the adjustment
LENS
Blinking (Red Lamp)
Light on (Red Lamp)
X7
30
button on the unit to turn off
About Cool Down
mode
●
The Cool Down mode is a
buttons
function to cool down the lamp
for approximately 60 seconds
after projection is complete.
This function prevents the
internal parts of the unit from
deformation or damage due to
overheating of the lamp. It also
prevents lamp blowout and
premature shortening of lamp
life.
●
During Cool Down mode, the
[STANDBY/ON] indicator blinks
in red.
●
After the Cool Down mode is
complete, the unit automatically
returns to standby mode.
●
Do not pull out the power plug
during Cool Down mode. This
may shorten the lamp life and
cause a malfunction.
●
The slide cover will not close
if the [Lens Cover] is set to
[Open] in the [3. Installation]
- [3-1. Lens Control] menu.
(Reference page: 66)
90 70
ENGLISH
MEMO
37
Publicidad
