Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
• Unit will not start.
• Battery will not charge.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
1-800-544-6986.
WARNING:
tool could be hazardous.
BATTERY REMOVAL AND DISPOSAL
This product uses Lithium Ion rechargeable and recyclable batteries. When the batteries
no longer hold a charge, they should be removed from the Vac and recycled. They must
not be incinerated or composted.
The batteries can be taken for disposal to a BLACK+DECKER, Company-Owned or
Authorized Service Center. Some local retailers are also participating in a national
recycling program (see "RBRC
the batteries to a BLACK+DECKER Company-Owned or Authorized Service Center, the
Center will arrange to recycle old batteries. Or, contact your local municipality for proper
disposal instructions in your city/town.
To remove the battery pack for disposal:
1.) First, before attempting to disassemble the product, turn it on and leave it on until the
motor completely stops insuring a complete discharge of the batteries.
2.) Remove nozzle.
3.) Using a phillips screwdriver, remove the two exposed screws near the front of handle
securing the battery housing.
4.) Lift the housing cover away from the assembly, exposing the batteries.
5.) Lift out the battery assembly and detach the lead connection.
6.) Dispose of batteries as per recommended guidelines.
The RBRC ® Seal
The RBRC ® (Rechargeable Battery Recycling Corp oration)
Seal on the nickel cadmium, nickel metal hydride or lithium-ionbatteries (or battery packs) indicates that the
costs to recycle these batteries (or battery packs) at the end of their useful life have already been paid by
BLACK+DECKER. In some areas, it is illegal to place spent nickel cadmium, nickel metal hydride or lithium-
ion batteries in the trash or municipal solid waste stream and the Call 2 Recycle ® program provides an
environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with BLACK+DECKER and other battery users, has established the pro-
gram in the United States and Canada to facilitate the collection of spent nickel cadmium, nickel metal
hydride or lithium-ion batteries. Help protect our environment and conserve natural resources by returning
the spent nickel cadmium, nickel metal hydride or lithium-ion batteries to an authorized BLACK+DECKER
service center or to your local retailer for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery. RBRC ® is a registered trademark of Call 2 Recycle, Inc.
Troubleshooting
Possible Cause
• Battery not charged.
• Charger not plugged in.
• Surrounding air
temperature too hot or
too cold.
The use of any accessory not recommended for use with this
TM
Seal"). Call your local retailer for details. If you bring
7
Possible Solution
• Check battery charging
requirements.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more details.
• Check current at receptacle by
plugging in a lamp or other appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and tool to a
surrounding air temperature
of above 40 degrees F(4.5°C) or
below 105 degrees F (+40.5°C).
Publicidad
