Publicidad
Idiomas disponibles
Idiomas disponibles
30 OPERATION
Add Garments
Use this function to add garments or remove foreign
objects like coins or keys after the cycle has started.
1
Press Add Garments. The cycle pauses and the
door unlocks.
2
Open the door, add garments or remove foreign
objects, and close the door.
3
Press the Start/Pause button to start the cycle.
The cycle continues automatically.
NOTE
• After checking the water level/temperature
conditions for safety, the door unlocks once the
wash movement has stopped. (Door Lock LED
turns off.)
• If the water level is too high, the door will not unlock,
and the Add Garments option cannot be used.
• If the temperature in the tub is higher than 113 °F
(45 °C), a short warning chime sounds and Add
Garments is not allowed for safety.
• Add Garments is disabled during the Tub Clean
cycle or while a cycle is in Spin mode for safety.
• To preserve wash performance, wash time may be
extended depending on when garments are added
to a cycle.
WARNING
• Be careful when opening the door as wet laundry
may drip or fall out when the door is opened.
• Do not attempt to force the door to open when
locked. Doing so could result in damage to the
machine, malfunction, or personal injury.
Turbo Wash™
Adding the Turbo Wash™ option reduces the cycle
time while still providing similar wash performance to
the same cycle without Turbo Wash™.
NOTE
• The Turbo Wash™ option cannot be used with all
cycles.
• Turbo Wash™ defaults to on for Normal, Heavy
Duty and Perm.Press wash cycles.
Cold Wash
This option saves energy by using cooler water while
increasing the wash and rinse times to maintain wash
performance.
NOTE
• Wash time will increase up to several minutes with
the Cold Wash option.
• For best wash results, only wash small loads (less
than 8 lb) with the Cold Wash option.
Extra Rinse
This option will add an extra rinse to the selected
cycle. Use this option to help ensure the removal of
detergent or bleach residue from fabrics. Liquid fabric
softener, if used, is always dispensed in the final
rinse. Pressing the Extra Rinse button twice will add
two additional rinses to the cycle.
Rinse+Spin
Select this cycle to rinse and spin a load separately
from a regular cycle. This can be helpful in preventing
fresh stains from setting in fabrics. You can change
the spin speed by pressing the Spin button.
1
Press the Power button to turn on the washer.
2
Press the Rinse+Spin button.
3
Press the Start/Pause button to start the cycle.
Control Lock
Use this option to disable the controls. This feature
can prevent children from changing cycles or
operating the machine. The feature does not lock
the door. Once the Control Lock is set, it must be
deactivated before any controls, except the Power
button, can be used. Once the washer has shut off,
the Power button will allow the machine to be turned
on, but the controls will still be locked. When the
controls are locked,
the estimated time remaining.
Locking/Unlocking the Control Panel
Press and hold the Control Lock button for 3
seconds.
NOTE
• Turning off the power will not reset the Control Lock
function. You must deactivate Control Lock before
you can access any other functions.
• When Control Lock is turned on, you cannot operate
any buttons except the Power button.
will display alternately with
Publicidad
