Publicidad
Idiomas disponibles
Idiomas disponibles
5
Wipe off any moisture with a dry towel or cloth
after cleaning.
6
Replace the detergent dispenser drawer.
WARNING
• Do not spray water inside the cabinet. Doing so
may cause fire or electric shock.
Cleaning the Door Seal
Clean the door seal once a month to prevent build-up
of dirt.
1
Wear rubber gloves and protective goggles.
2
Dilute 3/4 cup (177 ml) of liquid chlorine
bleach in 1 gallon (3.8 L) of water.
3
Wipe around the door seal.
Soak a sponge or a soft cloth in this diluted
solution and wipe all around the door seal.
4
Wipe dry.
After cleaning, wipe up any moisture with a dry
towel or cloth.
5
Leave the door open to allow the door seal to
dry completely.
CAUTION
• Cleaning the door seal with undiluted bleach
may cause malfunction of the door seal and
washer parts. You must add water to the bleach
before using it.
Cleaning the Water Inlet
Filters
If the washer does not fill properly, an error message
will show on the display. The inlet valve filter screens
could be plugged by hard water scale, sediment in
the water supply, or other debris.
CAUTION
• The inlet screens protect the delicate parts of
the inlet valve from being damaged by particles
that could enter the valves with the water supply.
Operating the washer with these filters removed
could cause a valve to stick open resulting in
flooding and/or property damage
• If you use the washer in an area with hard water,
the inlet filter may clog due to lime buildup.
1
Turn off both water faucets completely.
2
Unscrew the hot and cold water hoses from
the back of the washer.
3
Carefully remove the filters from the water
valves.
4
Remove foreign objects and soak the filters in
white vinegar or a lime scale remover.
If using a lime scale remover, follow the
manufacturer's instructions. Be careful not to
damage the filters while cleaning them.
5
Rinse filters thoroughly and press them back
into place.
6
Flush then reattach the water hoses.
Before reattaching the hoses, flush the hoses and
water lines by running several gallons of water
into a bucket or drain, preferably with the faucets
wide open for maximum flow.
NOTE
• An
message may blink on the display when the
water pressure is weak or an inlet filter is clogged
with dirt. Clean the inlet filter.
37
MAINTENANCE
Publicidad
