BWT BC30 Manual De Usuario página 8

Pool Preparation
If there are stones, roots or metal corrosion in contact with the underside of the
-
liner, discard them prior to using the pool vacuum. If necessary, seek assistance
from a qualified professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to
perform the necessary repairs or perform a liner replacement prior to using the
pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing
the pool vacuum into the water.
OPERATION
WARNING!
Make sure the pool vacuum is off

Do not use the pool vacuum if any damage is detected.

Oil stain could occur due to possible leakage of lubricants applied to the

O-ring.
Do not operate this pool vacuum if there are people/pets present in the

water.
Make sure the pool vacuum is fully immersed in the pool before initiating

operation. The minimum water level required to operate the pool
vacuum must reach above the power ON/OFF switch of the pool
vacuum when it is held in a vertical position. Operating the pool vacuum
when it is not immersed correctly could damage the unit and void the
warranty.
DO NOT use the pool vacuum without an intact filter cage in place.

Using your pool vacuum without an intact filter cage in place will VOID
your warranty.
DO NOT leave the pool vacuum in the water when it is not in use.

1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and turn the power ON/OFF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed
into the pool. Otherwise it may bend the pole connector and damage it during the
process.
Inverkehrbringer: BWT Pool Products GmbH, Rödgener Straße 8-9, 06780 Zörbig 7/155