Descargar Imprimir esta página

Genesis GCS120 Manual Del Operario página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

WArNING:
in the reverse direction could cause the saw to climb up on the work piece and back
toward you.
• Release the trigger and allow the blade to come to a complete stop.
• Lift the saw from the work piece.
• Repeat this procedure for the remaining sides, and then clear the corners out with a hand saw or jig saw.
WArNING:
blade exposed could lead to serious injury.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. use clean cloths to remove dirt, dust, oil, grease, etc.
WArNING:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these
types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool
using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.
TWO-YEAr WArrANTY
This product is warranted free from defects in material and workmanship for 2 years after date of purchase. This
limited warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser
is covered by this warranty and it is not transferable. Prior to returning your tool to store location of purchase,
please call our Toll-free Help Line for possible solutions.
THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT COVERED BY THE 2 YEAR WARRANTY.
TOLL-FrEE HELP LINE
for questions about this or any other GeNeSIS™ Product, please call Toll-free:
www.genesispowertools.com
Or visit our web site:
©Richpower Industries, Inc. All Rights reserved
Richpower Industries, Inc.
736 Hampton Road
Williamston, SC 29697
Printed in China, on recycled paper
12 Amp, 7-1/4" Circular Saw
Operator's Manual
Always cut in a forward direction when pocket cutting. Cutting
Never tie the lower blade guard in a raised position. Leaving the
Do not at any time let brake fluids, gasoline, petroleum-based
888-552-8665
GCS120
.

Publicidad

loading