1. Safety Guidelines
Please read this manual thoroughly before installing & using the instant water heater. Failure to comply with the safety,
installation or operating instructions will void the product warranty. Manufacturer and distributor of the product will
not be liable for any damage or injury caused by the failure to comply with the installation and operating instructions
specified in this manual or the improper use of the product. Ensure that this product is installed in accordance with the
national, state or local electrical and plumbing codes applicable to your area, and as specified in our instructional guide
to get the best performance from your Instant Water Heater.
This product has more than one power connection source. Do not attempt to install, clean, inspect, disassemble,
service or repair the water heater without shutting off all the power sources to the unit on the main electrical panel
using the circuit breaker.
WARNING: Failure to adhere might result in severe injury or death. The water heater must be installed in
compliance with all national, state, provincial and local electrical and building regulations. We recommend that
you consult a qualified electrician and a qualified plumber if you have questions about anything relating to codes
or regulations for this product.
This product is intended for household and indoor use only. Do not immerse in water.
The breaker used to power this unit must be grounded by means of the electrical panel.
The heater must be directly connected to dedicated circuit breakers on the main electrical panel.
Do not install the heater where it may be subjected to direct sunlight, rain, splashing water, moisture/humidity or
freezing temperatures.
This unit is intended for heating water only. Do not attempt to use the unit for heating any other kind of liquid.
2. About Your Atmor Electric Tankless Water Heater
Congratulations on making the decision to purchase one of the best and finest Instant Water Heaters currently available
in the market today! Your new Instant Water Heater features advanced water flow rate and temperature sensors which
are designed to modulate power to the heating elements to maintain a user-selected output water temperature range
for 18KW/24KW/29KW/36KW: 86°F (30°C) to 122°F (50°C) (subject to the temperature of the incoming water).
WARNING: When selecting the water temperature setting of your Instant
Water Heater's thermostat, factors such as safety and energy conservation should
be considered. Continuous exposure of the skin to water temperatures above
120°F (49°C) can result in severe burns or death. The maximum temperature
to be set on this Instant Water Heater's thermostat is 122°F (50°C). Always
take precaution to feel the water before bathing or showering to make sure the
temperatures are not too hot. You are required to read and comply with the Time/
Temperature Relationship Chart on the following page to determine the right water
temperature for your home.
Temperature
120°F (49°C)
122°F (50°C)
4
You may require a 120°F (49°C) or lower thermostat setting to prevent
contact with "HOT" water, if you have small children, disabled, or elderly persons
in your home. The temperature of the water is regulated by the electronic control on the front of the water heater.
Exposure time resulting in scalding
Around 5 minutes of exposure
Around 3 minutes of exposure
• Children, disabled and
elderly are at high risk of
being scalded.
• See instruction manual
before setting your desired
hot water temperature
• Always feel water before
bathing or showering