Safety Instructions
OVERVIEW
This manual must be read carefully before attempting to install the water heater. If you do not follow the safety
rules or the instructions outlined in this manual, the unit may not operate properly and it could cause property
damage, serious bodily injury or death.
Atmor will not be liable for any damages because of failure to comply with the installation and operating
instructions outlined in this manual or because of improper use. Improper use includes the use of this appliance
to heat any liquid other than water.
improper use voids the warranty. Never remove the unit's cover unless the electricity is turned off.
01
The water heater must
be installed by a licensed
electrician and in compliance
with all local electrical and
building regulations.
04
The heater must be installed
according to the installation
instructions (see figures).
07
The plumbing installation
requires metal or reinforced
pipes that can withstand a
minimum pressure of 8 bar.
(Other types of pipes will
cause damage.)
1
Failure to comply with the installation and operating instructions or
02
Caution: The appliance must
be grounded.
05
The plumbing installation
must be completed before
the electrical installation.
08
Do not install the heater
where it may be subjected
to direct sunlight, rain and/
or a constant spray of
water.
03
A dedicated circuit breaker
must be installed on the
power distribution panel.
06
The heater operates at a
minimum water flow rate of
0.5 gallon/minute.
09
Always contact your
local authorized licensed
proffessional for service.