Descargar Imprimir esta página

Crosley YFW450 Serie Manual Del Propietario E Instalación página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting started
N
Tumble
or
Ext Tumble
O
P
Q
or
(depending
on model)
R
(appearance will vary
and not all features
on all models)
10
Tumble Care or Extended Tumble (on some models)
Freshly tumbles your garments periodically for up to 8 hours after the wash cycle is complete
to lessen the setting of wrinkles and creases when you are not able to move clothing to the
dryer right away .
At the end of the cycle, the display will scroll "END" and after ten minutes the Tumble Care or
Extended Tumble will begin . It can be stopped at any time by pressing the Power button .
NOTE: The Tumble Care or Extended Tumble option cannot be added to the My Cycle
feature .
Volume (on some models)
This button has two functions:
■ To change the loudness of the end of cycle signal, press the button as many times as
needed to reach the desired volume . There are four sound levels including OFF .
■ To turn the button sounds ON/OFF, press and hold the button for 3 seconds .
Cycle Signal (on some models)
Use the Signal pad to change the volume of the end of cycle signal .
Press the pad until you reach the desired volume .
Lock Controls or Lock (depending on model)
You can lock the controls to prevent any selections from being made . Or you can lock or
unlock the controls after you have started a cycle .
Children cannot accidentally start the washer by touching buttons with this option selected .
To lock the washer, press and hold the Lock Controls or Lock button for 3 seconds .
To unlock the washer controls, press and hold the Lock Controls or Lock button for 3
seconds .
A sound is made to indicate the lock/unlock status .
The indicator light above the button will illuminate when the controls are locked .
NOTE: The Power button can still be used when the machine is locked .
Display
Displays the approximate time remaining until the end of the cycle .
NOTE: The cycle time is affected by the water pressure in your home and the balance
of the load in the washer . You may see the time remaining on the display increase to
accommodate a slower spin speed to handle unbalanced loads .
On some models, cycle status is also displayed and certain features such as Delay Wash or
Steam are shown indicating they have been selected .
If an out-of-balance condition is detected by the washer, the Spin light will blink during
the remaining portion of the cycle and will stay illuminated for a short time after cycle
completion . On some models, there is also a "Load Rebalancing" message displayed . When
this occurs, the washer is taking actions to correct the out-of-balance condition and complete
the cycle normally . In some cases, the washer may not be able to balance the load and
spin up to full speed . If you notice the load is more wet than usual at the end of the cycle,
redistribute the load evenly in the wash tub and run a Drain + Spin cycle .
49-3000065

Publicidad

loading

Este manual también es adecuado para:

Yfw450spmdgYfw450spmdw