Descargar Imprimir esta página

Crosley YFW450 Serie Manual Del Propietario E Instalación página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

LOCATION OF YOUR WASHER
DO NOT Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions . The ambient temperature should
never be below 60°F (15 .6°C) for proper washer
operation .
2. In an area where it will come in contact with curtains
or drapes .
3. On carpet . The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per 30
cm) . To make sure the washer does not vibrate or
move, you may have to reinforce the floor .
NOTE: If floor is in poor condition, use 3/4"
impregnated plywood sheet solidly attached to existing
floor covering .
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear, Top = 0" (0 cm)
• When installed in closet: Sides, Rear, Top = 0" (0 cm),
Front = 1" (2.54 cm)
• Consideration must be given to provide adequate
clearance for installation and service .
• Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches (387 .1 cm
open area . If the closet contains both a washer and a
dryer, doors must contain a minimum of 120 square
inches (774 .2 cm
) of open area .
2
MOBILE HOME INSTALLATION
Installation must conform to Standard for Mobile Homes,
ANSI A119 .1 and National Mobile Home Construction
and Safety Standards Act of 1974 (PL93-383) .
16
Installation Instructions
) of
2
ROUGH-IN DIMENSIONS
FRONT
27 .0"
(68 .6 cm)
SIDE
33 .6" (85 .3 cm)
NOTE: With pedestal, 52 .6"
Stacked, 84"
39 .8"
(101 .09 cm)
39 .8"
(101 .09 cm)
49-3000065

Publicidad

loading

Este manual también es adecuado para:

Yfw450spmdgYfw450spmdw