Publicidad
Idiomas disponibles
Idiomas disponibles
Fuses:
2 x 15 Amperes
Automatic Turn-On Selection: KICKER powered enclosures offer three different automatic turn-on modes
that can be selected on the side panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode
causes the REM terminal to have +12V out for turning on additional amplifi ers.
• Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18
gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM on the quick-
connect power harness. This is the preferred automatic turn-on method.
• DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset
mode detects a DC offset from the HI-Level speaker outputs when the source unit has been turned on.
• Signal Sense Turn-On: The Audio setting is the fi nal alternative for Automatic turn-on. This is a Signal Sense
turn-on method that detects the incoming audio signal from your source unit and automatically turns on
your powered enclosure. This turn-on method will not work properly if the input gain control is not set
appropriately.
2011 PES10C - PECVR12 RevE.indd 5
2011 PES10C - PECVR12 RevE.indd 5
All manuals and user guides at all-guides.com
DC OFFSET
AUTO
INPUT
GAIN
TURN ON
PHASE
LEVEL
REM
0°
LO
AUDIO
180°
HI
X-OVER
FREQ.(Hz)
INPUT
REMOTE
BASS
BASS
BOOST(dB)
PWR/PRT
GND REM +12V
5
9/14/2010 1:55:53 PM
9/14/2010 1:55:53 PM
Publicidad
