Publicidad
Before you begin, please make sure that you
Have all components collected.
1
Check that all components do not have compatibility problems with each other or with the case.
2
If possible, assemble the components outside the case first to make sure they are working.
3
Keep the motherboard manual ready for reference during installation.
4
Prepare a Philips screwdriver.
5
01
Unscrew three screws from the rear of the chassis then remove the top cover.
Lösen Sie die drei Schrauben von der Rückseite des Gehäuses, entfernen Sie dann die obere Abdeckung.
Dévissez les trois vis à l'arrière deboîtier et ensuite retirez le panneau supérieur.
Destornille los tres tornillos de la parte posterior del chasis y luego retire la cubierta superior.
Svitare le tre viti sul retro dello chassis per rimuovere il cover superiore.
Отвинтите три винта с задней части корпуса, затем снимите верхнюю крышку.
先用螺絲起子鬆開三顆螺絲,再取下上蓋板.
先用螺丝起子松开三颗螺丝,再取下上盖板.
ケースの後ろからネジ3本を外し、 それから上部カバーを取り外します。
케이스 뒷편의 3개의 나사를 풀은뒤 상부 커버를 제거합니다.
3
Milo Series
Installation Chart
ML06-E
Publicidad
