MAAX 137200 Guia De Instalacion página 10

1
x2
With the sliding doors fully open, install the door seal on the
edge of the stationary panel, as indicated on the figure. Cut it as
required. NOTE: The door seal lip must face inside the cabin, as
indicated. Repeat the procedure for the other stationary panel.
1
To ensure tightness of the shower door, apply a high-quality silicone caulk, as indicated.
Let the caulk cure for 24 hours before using the shower.
Note: Apply silicone caulk to the locations outside the shower cabin.
7 - INSTALLATION OF SEALS 7 -
2
indicated. Repeat the procedure for the other sliding panel.
NOTE: When the sliding door panels
are closed, the seals are facing each
other, as indicated above.
8 - SILICONE APPLICATION 8 -
10
Install the door seal on the rear edge of the sliding door
panels, as indicated on the figure. Cut it as required.
NOTE: The door seal lip must face outside the cabin, as
x2