Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning Your Carpet
TIP: Thorough vacuuming before deep cleaning will prevent early clogging in the
nozzle and lint trap.
1
Plug the power cord into a
properly grounded outlet.
4
Recline the machine by pressing the
gray release switch with your foot.
5
ATTENTION: To prevent damage to Berber carpets, avoid repeated strokes in
the same area.
NOTE: You may notice hair and debris deposits on the carpet or in the tank that were
loosened by the cleaning action (especially with newer carpets that may have never been
deep cleaned before). This debris should be picked up and thrown away.
2
Set the ReadyTools™ Dial
to the FLOOR CLEANING
setting.
NOTE: Do not overwet the carpet. Also
take care not to run over loose objects,
edges of area rugs, or the power cord.
NOTE: Stalling the brush by running over
loose objects, edges of area rugs, or the
power cord may cause the belts to snap
and break.
While pressing the trigger, make one slow pass
forward and back to put water and formula down.
Release the trigger and make one slow pass
forward and back over the same area to pick up
the water and formula that was just put down.
Repeat until the liquid coming up appears clean.
Continue passes without pressing the trigger until
you can't see any more water being suctioned up.
3
Press the Power Switch to
turn the machine ON.
www.BISSELL.com
9
Publicidad
