Publicidad
Idiomas disponibles
Idiomas disponibles
6. Install the DC Power Unit
Ribs
Unthread the screws from the battery box to remove the battery box cover.
NOTE: Do not mix used and new batteries.
Insert four D batteries (provided). Reinstall the battery box cover and secure with
the screws.
Align the grooves on the battery box with the ribs on the side of the control box.
Mark the location of the mounting holes.
NOTE: The provided wall anchors are for concrete wall installation. Use the
appropriate wall anchors depending on your wall material.
Drill the holes per the anchor manufacturers instructions. If using the provided
wall anchors, drill 1/4" (6 mm) pilot holes.
Slide the battery box onto the ribs on the side of the control box. Secure with the
screws.
Kohler Co.
Power Cord
Battery Box
11
Power Cord
Control Box
1419080-2-A
Publicidad
