Publicidad
Idiomas disponibles
Idiomas disponibles
2. Install the Tubing (Recommended)
U-Clamp
90° Elbow
NOTE: PVC fittings and tubes (not provided) can be attached to the mounting
bracket to route the spout cables and tubes to the control box. Consult the
specification sheet to determine the control box location.
Glue and connect a straight PVC tube to the mounting bracket as shown. Verify
that the tube is long enough to reach the control box.
Secure the PVC tube onto the mounting bracket with u-clamps (not provided).
Glue a 90 degree PVC elbow at the end of the PVC tube at the control box
installation location.
Reinstall the plaster guard over the mounting pin.
NOTE: The inished wall thickness must be 1/4" (6 mm) minimum to 1-3/8" (35 mm)
maximum.
Finish the wall with a 1-1/4" (32 mm) hole for the spout.
Finish the wall with a 1-1/4" (32 mm) hole for the cables and tubing.
Kohler Co.
Plaster
Guard
7
1- 1-1/
(32 mm)
1- 1-1/
(32 mm)
1419080-2-A
Publicidad
