Publicidad
Idiomas disponibles
Idiomas disponibles
7. Connect the Control Box Wires
Sensor
Assembly
Cable
Plastic
Tube
IMPORTANT! Verify that the cables are not pinched when connecting to the control
box.
IMPORTANT! The area in front of the sensor must be free of objects during the 2
minute learning cycle or the soap dispenser may not function properly.
Connect the sensor assembly cable from the spout to the sensor assembly
connector from the control box.
Connect the LED assembly cable from the spout to the LED assembly connector
from the control box.
Connect the power supply connector from the battery box to the power supply
connector from the control box.
Allow 2 minutes for the sensor to cycle through the automatic sensing distance.
1419080-2-A
LED
Assembly
Cable
Plastic
Tube
Sensor Assembly
Connector
Power Supply
Connector
12
Power
Supply
Connector
LED Assembly
Connector
Air Pump
Outlet
Soap Pump
Outlet
Kohler Co.
Publicidad
