Installation; Procedure For Use - Schulz AIR Plus Spray Split Manual De Instrucciones

8. INSTALLATION

MODEL
Air Plus Spray Schulz - Split
Air Plus Spray Schulz - Compact
ELECTRIC SAFETY
Figure 3 shows the connection plug-inlet. For your safety against electric shock, only use your paint spray
in structures with residual differential circuit breaker (RD) of 30mA. If necessary, hire an electrician you trust and
ask for the installation of this safety component part.

9. PROCEDURE FOR USE

ATTENTION
area. - When using an electric product, certain basic safety precautions must be observed in order to reduce
risks of fi re, electric shock and personal injury.
- Make sure the paint spray is turned off and disconnected from the energy inlet before starting the procedures
that follow the preparation for use.
- Accident danger! Never press the activation trigger during the adjustment of the paint regulator.
- Never point the gun in your direction, especially when it is energized.
Power Voltage
(Min. section)
W V
127
350
220
127
300
220
TABLE 8.1 – ELECTRIC INSTALLATION
FIGURE 8.1 – CONNECTION OF THE PLUG TO THE INLET
- Before using the paint spray, make sure there are no people or pets in the operating
0
45
30
FIGURE 9.1 – CONNECTION OF THE PLUG TO THE INLET
Cable Fuse Circuit Maximum distance of
breaker the distribution board
mm² A
1,5 6
15
35
Extension up to 10m
(Minimun section)
meters mm²
30
50
1,5
40
60