Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
BEFORE USING YOUR
BEER DISPENSER
INSTALLATION OF
BEER DISPENSER
ELECTRICAL
CONNECTION
All manuals and user guides at all-guides.com
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• 1 Safety Guard Rail
• 1 Drip Tray (2 Pieces)
• 1 CO2 Cylinder Support
• 1 CO2 Regulator (Box)
• 1 CO2 Empty Cylinder(Box)
• 1 CO2 Air Line Hose (Red)
• 1 Beer Keg Coupler (Box)
• 1 Beer Tower
• Before plugging in the keg cooler, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• This appliance is designed to be free standing only, and should not be
recessed or built-in.
• Place your Beer Dispenser on a floor that is strong enough to support
the Beer Dispenser when it is fully loaded.
• Allow 3 inches of space between the back and sides of the Beer
Dispenser, which allows the proper air circulation to cool the compressor.
• Locate the Beer Dispenser away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the Beer Dispenser not to
perform properly. This unit is not designed for outside installation (ie
garages, porches, etc.)
• Avoid locating the Beer Dispenser in excessive humidity.
• Plug the Beer Dispenser into a dedicated, properly installed-grounded
wall outlet. Do not under any circumstances cut or remove the third
(ground) prong from the power cord. Any questions concerning power
and or grounding should be directed toward a certified electrician or an
authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down
for 2-3 hours before placing any contents in the Beer Dispenser
compartment.
Improper use of the grounded plug can result in the risk of
electrical shock. If the power cord is damaged, have it replaced by
an authorized service center.
This Beer Dispenser should be properly grounded for your safety. The
power cord of this Beer Dispenser is equipped with a three-prong plug
which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong
from the power cord supplied.
Use of extension cords is not recommended.
6
• 1 Pull Handle (Beer TowerFaucet)
• 4 Plugs: For Guard Rail Holes
• 1 Metal Plate For Cabinet Bottom
• 2 Steel wire shelves
• 1 Steel Clamp for Red Hose
• 4 Castors (2 front with locks)
• Metal Washers
• 1 Rubber Washer
WARNING
Publicidad
