Installation Instructions
ELECTRICAL
CONNECTION (cont)
Beer Keg Installation Instructions
Keg Installation Sketch
SINGLE GAUGE
PRESSURE
REGULATOR
TOWER
CO2 TANK
RED PRESSURE HOSE
All manuals and user guides at all-guides.com
This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical
outlet with three-prong ground receptacle. The cord should be secured
behind the Beer Dispenser and not left exposed or dangling to prevent
accidental injury.
Never unplug the Beer Dispenser by pulling the power cord. Always grip
the plug firmly and pull straight out from the receptacle.
CO2 cylinders contain high-pressure compressed gas which can
be hazardous if not handled properly. Make sure you READ and
UNDERSTAND the following procedures for CO2 cylinders
BEFORE INSTALLATION.
1. ALWAYS connect the CO2 cylinder to a regulator. Failure to do so
could result in explosion with possible injury when the cylinder valve is
opened.
2. NEVER connect the CO2 cylinder directly to the keg.
3. ALWAYS follow correct procedures when cylinders are changed as per
local codes.
4. ALWAYS secure the CO2 cylinder in an upright position.
5. NEVER drop or throw a CO2 cylinder.
6. ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in
a cool place (preferably 70°F). Securely fasten with a chain in an
upright position when storing.
7. ALWAYS ventilate and leave the area immediately if CO2 leakage has
occurred.
8. ALWAYS check the D.O.T. test date on the cylinder neck before
installation. If over five (5) years, do not use, return cylinder to gas
supplier.
9. NEVER connect a keg without a safety pressure release.
a. One at or on the CO2 regulator
b. One at or on the product coupler or in the pressure gas line.
• Install the four castors (2 locking castors at front) into the unit's bottom
(four screw holes pre-supplied) Figure (1) before installation. Figure (II)
is the final version. Put the metal washers provided on the castors
FAUCET ASSEMBLY
before installing them.
TOWER
CLEAR HOSE
WITH WING NUT
AMERICAN
SANKEY TAP (COUPLER)
KEG
WARNING
CO2 GAS CAN BE DANGEROUS
METAL
CASTORS
WASHERS
Put metal washers
on castors.
Figure 1
7
Figure 2