Yisunf AXD-808 Manual De Instrucciones página 6

Power Supply Way
Battery Installation
1. Remove the battery cover.
2. Remove the used batteries if there are any.
3. Insert new batteries into the battery compartment as shown,
taking care that the polarities (+) and (-) are correct.
4. Close the battery cover. Use only 1.5V, 4 x AAA alkaline batteries or
use "NiMH" reusable batteries.
CAUTION:
Please pay attention to the polarity of batteries.
If the low battery symbol blinks on the display, please replace all batteries
with new ones. Do not mix used and new batteries. It may shorten the
battery life, or cause device malfunction. Remove the batteries if the
device is not to be used for a long time. Otherwise the batteries may leak
and cause a malfunction.
USB Connecting
You may also operate this device using the Type-C cable (included in the
package) with the USB-C Power adapter(output 5V DC1A) when
connected with electrical outlet.
Note:
Use only the approved adapter to avoid damaging the device.
a) Ensure that the adapter and cable are not damaged.
b) Plug the cable into the adapter port on the right side of the device.
c) Plug the adapter into your socket, power bank, computer, etc.
d) Please take out all the batteries when using the USB to operate the
device.
e) If electrical power is interrupted accidentally, please reinsert and reset
the device.
8
System Setting
1.Setting the User:
(1) In shutdown or standby state, press and hold the [SET] button for about 3
seconds until User icon 1 or 2 flashes on the screen. (The initial user is 1.)
(2) Press the [MEM] button to select the User (1 or 2) that needs to be stored.
(3) Press the [SET] button to confirm the User (1 or 2) and enter into the unit
setting.
2.Setting the Unit:
(1) Press the [MEM] button to switch the unit between kPa and mmHg.
When the screen displays
When the screen displays
(2) Press [SET] button to confirm the unit.
3.Press the [START/STOP] button to save all the settings.
Note: All the memories of the selected user will be consistent with your unit
setting.
, the unit of the device is mmHg.
, the unit of the device is kPa.
9